Izšla je nova verzija programa logger32, verzija 3.7.0.
http://www.logger32.net/program.html
SPREMEMBE:
1) There was a bug in the code (now fixed) where if using language DLLs the
"Show 0 for zero" menu item was not shown correctly.
2) Support added for SAT_MODE, SAT_NAME and PROP_MODE fields when using the
clipboard to transfer info from an external application.
3) The number of macro buttons selected in the Sound Card Data Window were
not being remembered correctly in ver3.6.0. Bug corrected.
4) Following a KEPS update the initial predicted track for the selected
satellite was not being refreshed correctly.
Bug corrected.
5) When clicking on a spot in the DX Cluster window, the spot is loaded into
the Log Entry window and focus is automatically returned to the Log Entry
window. The same thing now happens when using the mouse in the great circle
projection to rotate the beam.
6) When Logger32 is booted, the focus should be on the Callsign field of the
Logbook Entry Window (no matter if the MDI Form is visible or not). By
typing FIND<ENTER> following a boot, the MDI Form is commanded to an X,Y
location of 0,0. This facility has been introduced so that the main MDI
form can be located if it was off screen for any reason.
7) The distance measurement for the satellite tracking now follows the
preferred distance unit selection.
Corrected a minor bug where the previous QSO window would not "follow"
whether there was an equals sign "=" after the call that is entered in the
Log Entry window.
9) The DVK has been enhanced to support the triggering of messages stored
under the microHam router software.
This ONLY applies to those microHam units that have a DVK ability. For new
DVK option, on the DVK Window click CONFIG | MACRO SETUP
10) Code added to support Icom radios that have DATA on/off capability. New
option to enable/disable this is added to the Radio configuration Window.
If the option is enabled the command sequence to QSY and Icom is FREQ, MODE,
DATA and FREQ. If the option is disabled the command sequence is FREQ MODE
FREQ. If the transmission mode (derived from the BandPlan) is digital DATA
will be set on, otherwise DATA will be set off.
Digital modes are defined in Logger32 by clicking TOOLS | DATABASE
MAINTENANCE | SETUP DIGITAL MODES
11) The strobe line on the parallel port (used in the cw keyer and the
antenna selector) is now forced to a permanent low when Logger32 opens.
12) An additional information window added to show 425DX calendar
information in a similar way to the recently introduced iota window. See
new options under the UTILITIES menu. Because of this change, new language
files will be required.