N1MM+ in RTTY nastavitve MMTTY in 2TONE
Stran 1 od 1

Avtor:  s55o [ 27 Avg 2015, 06:45 ]
Naslov prispevka:  N1MM+ in RTTY nastavitve MMTTY in 2TONE

http://n1mm.hamdocs.com/tiki-index.php? ... TY+Support

http://n1mm.hamdocs.com/tiki-index.php? ... +and+Setup

http://n1mm.hamdocs.com/tiki-index.php? ... ital+Setup


http://www.ravingaboutradio.com/N1MM-MM ... L-2013.php

http://www.rttycontesting.com/tutorials ... rt-config/

http://www.rttycontesting.com/tutorials ... for-mmtty/


Avtor:  s54mtb [ 27 Avg 2015, 08:48 ]
Naslov prispevka:  Re: N1MM+ in RTTY nastavitve MMTTY in 2TONE

Priprava na vikend? 8)

Avtor:  s55o [ 27 Avg 2015, 20:45 ]
Naslov prispevka:  Re: N1MM+ in RTTY nastavitve MMTTY in 2TONE

Jaz jih že dobro poznam, mogoče pa še koga opogumim, pa da bo vse na enem mestu!
Malo je RTTY tekmovanj, kjer lahko delaš 24 ur z rate 50..
Se slišimo v tekmovanju! (s51a)

Avtor:  s55o [ 26 Avg 2016, 07:28 ]
Naslov prispevka:  Re: N1MM+ in RTTY nastavitve MMTTY in 2TONE


Za začetnike z n1mm dodajam naslednje tutoriale glede nastavitev n1mm in mmtty

http://n1mm.hamdocs.com/tiki-index.php? ... K+Contests
http://contestuniversity.com/attachment ... _2013e.pdf

Nekaj dobrih zadev, ki jih pozabljamo pred contesti pogledat še 1x:

http://n1mmplus.hamdocs.com/tiki-index. ... ssignments

*Edit a QSO without a mouse*: Ctrl+Q/A = Quick edit previous or next
call. Use Ctrl+Q to go backwards in the log, Ctrl+A to go forwards.
Change what needs to be changed and press enter to terminate Quick Edit.

*Unwipe a QSO*: Press Alt+W a second time. It's a toggle.

*Edit the function keys*: Alt+K (or right-click on the buttons)

*Delete the spotted contact in the **call frame*: Alt+D. This doesn't
blacklist the spot, but it is quick to do.

*Toggle in and out of Enter Sends Message Mode (ESM)*: Ctrl+M. If you
aren't using ESM for CW, you should be:
http://n1mmplus.hamdocs.com/tiki-index. ... ds+Message

*Use the mouse wheel*:
1. With the cursor over a bandmap, it zooms that bandmap. Try it.
2. With the cursor over the Telnet window it scrolls that window.
3. With the cursor over the Entry window it changes frequency:
a. By 20 Hz per click
b. By 1 kHz per click with Alt pressed
c. By 10 kHz per click with Ctrl pressed
d. By 100 kHz per click with Alt+Ctrl pressed

*Type a frequency or mode into the callsign textbox*: e.g.
1. 21044
2. 48
3. +5, -2
4. Ctrl with enter to set split freq as in 1-3 above. 48 Ctrl+Enter
**Jump from spot to spot by beam heading*:
1. In the Available window, click on the beam heading to sort by heading.
2. Use Alt+A & Alt+Shift+A to move up and down the list of spots in beam
heading order. This works for other sort orders as well.

*Change font size by window*: The main font in most windows size can be
adjusted by using the little up/down "font sizer" control in each of the
windows that this works in. Try it!

Try reviewing the Key Assignments page before your next contest. Pick
out a couple of features you did not know about to expoit.
http://n1mmplus.hamdocs.com/tiki-index. ... ssignments

Avtor:  s55o [ 26 Avg 2016, 09:29 ]
Naslov prispevka:  Re: N1MM+ in RTTY nastavitve MMTTY in 2TONE

Še posnetki za tiste, ki jim je lažje to početi po videu:
http://n1mm.hamdocs.com/tiki-index.php? ... nal+Videos

Stran 1 od 1 Vsi časi so UTC + 1 ura
Powered by phpBB® Forum Software © phpBB Group